Thursday, June 16, 2016
Nikon digital camera - Nikon D3200 – Disassembling procedure – How to replace the LCD display – Digital Camera Repair and service
Category: Digital Camera Repair and Servcie
Contents of this article
- How to remove the case
- How to disconnect connectors
- How to remove LCD
Nikon D3200
Locate the battery compartment on the bottom of the camera directly below the mode dial.
Find the marked arrow on the battery compartment door and firmly push following the arrow's direction to release the latch.
Release the latch and allow it to completely open. Insert the battery by following the diagram on the inside of the compartment door. Close the compartment door and firmly press on the latch until you hear a clicking sound.
Turn the camera so the bottom faces you. Locate and remove the 6 screws using a Phillips #00 screwdriver.
Locate the rubber grip directly below the shutter-release button. Lift the rubber grip using a plastic opening tool to locate and remove the two screws underneath using a Phillips screwdriver #00.
Locate and remove the 4 screws above the LCD screen, around the eyepiece. Use a razor to carefully peel the sticker off the +/- wheel to reveal the screw beneath.
Locate the connector cover left of the LCD screen. Unlatch the connector cover to reveal two screws. Remove screws.
Remove the rubber connector cover. Gently pull the back portion of the camera, one hand gripping the body and the other gripping the LCD screen.
Lay the back cover, LCD side down. Locate and remove the 9 screws around the silver protector plate.
Using a pair of tweezers, gently lift and remove the silver protector cover.
Lift the yellow connector. Flip the white clasp using a plastic opening tool, and pull out the tab.
Remove LCD screen.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment