Firmware Download

Category: Tablets repair and service 

Contents of this article 

Nextbook NX008HD8G

BATTERY REPLACEMENT PROCEDURE 

How to remove Back Panel

Using your finger, open the plastic tab to the right of the rear-facing camera.

Wedge your fingernail in between the back panel and the plastic tab and pull the plastic tab towards your body.

Using your finger, remove the SD card by pressing down on top of it (toward the bottom of the device) until you hear a clicking sound.

Once the card pops out, use your finger to pull the card completely out of the SD card slot.

Remove the 5 mm screw using the Phillips PH00 bit in the iFixit metal Screwdriver.

Use the plastic opening tool to separate the back panel by carefully sliding the narrow end of the tool between the front glass and back panel.

Use a second plastic opening tool to help pry the front glass from the back panel.
You will hear some cracking sounds when separating the front glass from the back panel.The back panel latches releasing the front glass.

Use your hands to completely separate the rest of the front glass from the back panel.

Do not to pull the device apart with too much force. If you do, you may break or bend the back panel.

Removing Battery 

Remove yellow tape with a black edge that covers the red, white and black wires.
The yellow tape with a black edge is safe to remove completely.

Remove the white masking tape covering the red white and black wires.

Desolder the red, white and black wires on the left side of the motherboard.

Use the flat end of the spudger to carefully separate the smaller, silver battery square from the digitizer.

The battery is very malleable, do not try to take it all off at once.

Use the flat end of the spudger to carefully separate the large battery from the digitizer.

The battery is very malleable, do not try to take it all off at once.